While my knowledge base doesn't contain specific documentation on safety guidelines for electricians performing roofing work on low-sloped roofs, I can provide general safety guidance based on industry best practices and OSHA regulations.

When electricians are performing roofing work on low-sloped roofs, it is crucial to prioritize safety due to the increased risk of falls and electrical hazards. Here are key safety guidelines to consider:

Fall Protection:

• Personal Fall Arrest Systems (PFAS): Utilize PFAS, including harnesses, lanyards, and anchors, when working near roof edges or unprotected sides. Ensure the PFAS is properly inspected before each use.
• Guardrails: Install temporary guardrails around the perimeter of the roof to prevent falls. Guardrails should meet OSHA height and strength requirements.
• Safety Nets: Consider using safety nets below the work area to catch falling workers or materials. Ensure safety nets are installed and maintained according to OSHA standards.
• Roof Widths: When determining fall protection methods, understand how OSHA defines roof widths, especially for low-sloped roofs. For roofs 50 feet (15.25 m) or less in width, a safety monitoring system may be used alone. For wider roofs, use a combination of safety monitoring and conventional fall protection.
• Written Fall Protection Plans: Develop a written site-specific fall protection plan that details the fall hazards and the measures to be taken to protect workers. This plan is required when conventional fall protection is not feasible or creates a greater hazard.

Electrical Hazards:

• De-energize Circuits: Always de-energize and lock out/tag out electrical circuits before starting any work. Verify the circuit is de-energized using appropriate testing equipment.
• Insulated Tools: Use insulated tools and equipment to prevent electrical shock. Inspect tools regularly for damage.
• Overhead Power Lines: Maintain a safe distance from overhead power lines. OSHA regulations specify minimum clearance distances based on voltage.
• Grounding: Ensure proper grounding of electrical equipment to prevent electrical hazards.
• Weather Conditions: Avoid electrical work during wet or stormy conditions. Water can increase the risk of electrical shock.

General Safety Practices:

• Training: Provide comprehensive training to all electricians on fall protection, electrical safety, and other relevant hazards. Training should cover the proper use of equipment and safe work practices.
• Housekeeping: Keep the work area clean and free of debris to prevent tripping hazards. Secure tools and materials to prevent them from falling off the roof.
• Communication: Establish clear communication procedures between workers on the roof and those on the ground. Use hand signals or radios to communicate effectively.
• Personal Protective Equipment (PPE): Ensure all workers wear appropriate PPE, including hard hats, safety glasses, and work boots.
• Emergency Procedures: Develop and communicate emergency procedures, including evacuation plans and first aid information.

Compliance with OSHA Regulations:

• 29 CFR 1926 Subpart M (Fall Protection): Comply with all applicable requirements of OSHA's fall protection standard. This includes the use of guardrails, safety nets, and personal fall arrest systems.
• 29 CFR 1926 Subpart K (Electrical): Follow OSHA's electrical safety standards for construction work. This includes requirements for lockout/tagout, safe work practices, and the use of PPE.
• Regular Inspections: Conduct regular safety inspections of the work site to identify and correct hazards. Document all inspections and corrective actions.
• Recordkeeping: Maintain accurate records of all training, inspections, and incidents. This information is essential for demonstrating compliance with OSHA regulations.