Pre-Task Plan: Electrical Conduit Installation

Date: [DATE] Work Area: [WORK AREA] Task Supervisor: [SUPERVISOR NAME]

1. Task Description

Installation of electrical conduits according to project specifications and applicable electrical codes.

2. Task Duration

Estimated Start: [START TIME] Estimated Completion: [END TIME]

3. Personnel Involved

• Electrician
• Apprentice Electrician
• Supervisor

4. Task-Specific Hazards and Controls

Hazard	Risk	Control Measures
Electrical shock	Electrocution, burns	Verify power is disconnected and LOTO is applied before starting work. Use insulated tools and wear appropriate PPE. [1]
Falls from elevation	Injury, death	Use appropriate fall protection equipment when working at heights. Inspect fall protection before use.
Struck by falling objects	Injury	Wear hard hats. Secure materials and tools to prevent them from falling.
Sharp edges of conduit	Cuts, lacerations	Wear gloves. Deburr conduit ends after cutting.
Awkward postures, repetitive motions	Musculoskeletal disorders	Use proper lifting techniques. Take breaks and rotate tasks to reduce strain.
Hazardous atmospheres (if applicable)	Asphyxiation, explosion	Test the atmosphere before entry. Use appropriate ventilation and respiratory protection.

5. Required PPE for Today's Task

• Hard hat
• Safety glasses
• Work gloves
• Safety boots
• Hearing protection (if required)

6. Tools and Equipment Needed

• Conduit bender
• Conduit cutter
• Reamer
• Screwdrivers
• Pliers
• Level
• Drill
• Measuring tape
• Personal Fall Arrest System (if required)

7. Pre-Start Checklist

Area Preparation

• Ensure adequate lighting in the work area.
• Clear the work area of obstructions and tripping hazards.
• Barricade the work area to prevent unauthorized entry.

Equipment Checks

• Inspect all tools and equipment for damage before use.
• Verify that all electrical tools are properly grounded or double-insulated.
• Check that the conduit bender is in good working condition.

Communication

• Review the task with all personnel involved.
• Identify potential hazards and discuss control measures.
• Establish clear communication signals.

8. Task Steps Overview

1. Review work order and gather necessary materials and tools.
2. Measure and mark conduit for cutting and bending.
3. Cut and deburr conduit.
4. Bend conduit to the required angles.
5. Install conduit supports and secure conduit in place.
6. Pull wires through the conduit (if applicable).
7. Inspect the completed installation.

9. Emergency Response for This Task

• Electrical shock → Immediately de-energize the circuit and administer first aid/CPR. Call emergency services.
• Fall from height → Call emergency services and provide first aid. Secure the area to prevent further incidents.

10. Task-Specific Precautions

• Do not work on energized circuits unless properly trained and authorized.
• Use only approved tools and equipment.
• Follow all applicable electrical codes and safety regulations.

Pre-Task Briefing Confirmation

All workers understand the task, associated hazards, and required controls.

Team Lead Initials: [___] Date: [DATE] Time: [TIME]

Safety powered by SALUS